Mistakes to Avoid when Installing and Hiring Siding Installation Company

You have often heard stories about your friend being duped by a bad contractor or substandard work they did for any of your friends or family. They went through this entire ordeal because of their mistakes when choosing a siding contractor. But everyone thinks they won’t experience the same thing. However, you cannot be so sure of it. It can happen to anyone.

If you don’t pay attention and do your due diligence before engaging a siding contractor, you will also become a cautionary tale for your friends and family. You need to contact a top-rated contractor like Alpine Exterior Contractors like Hardie board siding installer in Bellingham with 20+ years of experience. They are the most preferred contractors in and around Bellingham.

Builders skip re-inspecting at the installation to compensate for labor shortages or meet the project completion deadline, even though siding installation is more effortless. However, paying attention to proper installation will help you avoid future issues. Read on to discover how to avoid potential mistakes when installing siding.

Use of wrong nails

Using the wrong nails leaves a negative and lasting impact on your siding. Hot-dipped galvanized nails are required to install siding products. These nails come with a thick protective coating and can withstand the nail gun without damaging the coating. On the other hand, electroplated nails have a thinner layer and easily get damaged. As a result, rust streaks down the siding.

Inaccurate spacing

You need to make sure your siding contractor follows accurate spacing requirements. Inaccurate spacing is a common mistake people make while installing siding. This mistake resulted in the siding buckle. A minimum of 3/16″spacing at butt joints is suitable for lap-siding products. An alignment groove helps in the proper spacing of some panel siding products.

Improper caulking and flashing

Proper flashing is required for long-lasting durability of board and batten with panels installation and batten strips. The common mistake people encounter while installing board and batten is putting batten strip over z-flashing and horizontal seam. You need to make sure your contractor does not make such a mistake.

It is ideal to place the batten strip above the seam. At the same time, on the z-flashing, make sure to give a 3/8″ gap between the batten strip, z- flashing, and panel. You must make sure not to caulk the gap of 3/8″ at the seam for proper drainage.

Other than these, not staying on updated installation rules is a typical mistake contractors make when installing siding. It can also cause damage to your siding and affect its durability.

These are the mistakes people make while installing siding. However, mistakes start with avoiding key points when hiring a siding installation company. You should know the impact of these mistakes and avoid making them before you hire someone for the project.

These common mistakes include –

• Not getting a written estimate.
• Overlook warranty.
• Opting for the cheapest quote.

You should avoid making these mistakes and hire a siding company after researching them properly. Most importantly, stay away from the temptation of saving some pennies. Never opt for a siding installation company because they offer the cheapest quote. They must adjust their offer to provide a lower price, but in the end, you will pay extra money for repairs in the future.